Mounting Illustration

1) LINE A - centerline
2) LINE B - Axle Line
3) CIRCLE C - Position of front mounting bolt hole.
4) CIRCLE D - Position of rear mounting bolt hole.
5) MEASUREMENT E - Distance from back of plate to back of heel. NOTE: if this measurement exceeds 5/16”, next size plate is needed.

Mounting Tool List

1) Boot Last
2) Pencil or scribe
3) Snyder Marking Tool
4) Centerpunch
5) Hammer
6) Drill and F drill bit (.257 inch diameter)
7) 1” diameter steel punch
8) 7/16” small outside diameter socket and ratchet
9) Ruler or scale
10) Fine cut file - for filing burrs off of drilled holes
11) Hacksaw —(32 teeth/in.)